ASCOM D62 - Bedienungsanleitung PDF herunterladen (Seite 47)

TD 92477GB

2009-12-08/ Ver. C

User Manual

Ascom d62 DECT Handset

8 Alarm Operation

Note: The following system dependent features are applicable for d62 Protector only, see

Configuration Manual, Ascom d62 DECT Handset, TD 92639GB.

IMPORTANT: If a shared phone is used, it must be logged in to the system to be able to

send alarm. See 5.2 Log a Shared Phone On/Off on page 25.

8.1 Push-button Alarm

Press the red alarm button twice within two seconds to activate the alarm. An information

text is displayed, default “Personal Alarm” is displayed. The alarm is sent to the alarm

central that distributes it further. After that the handset returns to stand-by mode. Note

that you can always trigger the alarm when you are speaking, editing your settings, or

while the handset is locked.

8.2 Acoustic Location Signal

An alarm can be followed by an Acoustic Location Signal (ALS). The ALS is a signal from

the handset that sounds for a predefined period of time. The signal is silenced by pressing

the Mute button on the handset.

8.3 Test Alarm

Press and hold the red alarm button until the information text is displayed, default “Test

Alarm” is displayed.

8.4 Alarm with Location Information

Information about the handset’s location can be sent along with an alarm. The location

can be added as follows;

• Manually added by the user (see 8.4.1 Alarm with Data) or,

• An approximately location given by the closest Base Station (see Configuration Manual,

Ascom d62 DECT Handset, TD 92639GB) or,

• A precise location given by DECT location devices (see Configuration Manual, Ascom

d62 DECT Handset, TD 92639GB)

8.4.1 Alarm with Data

The data must manually be defined and stored by the user. To use the function, one Soft/

Hot key/Navigation key in the handset must be defined as a shortcut to the menu “Edit

alarm data, see 9.3 Short Cuts on page 51. The stored data is added to all types of alarm

at transmission.

8.5 Automatic Call after Alarm

A handset can be configured to call a pre-defined number after an alarm has been sent.

Depending on the settings, the call can be established in the following modes;

• Loudspeaking mode, or

• Monitor mode, or

• Normal mode

See Configuration Manual, Ascom d62 DECT Handset, TD 92639GB for more information.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 90 91

Keine Kommentare

ASCOM D62 - Bedienungsanleitung Seite 47